| dimensional | temperature | pressure | resistance | IR & optical pyrometers | electronics | mass
flow calibration/repair |
home |
| Phone: (412) 431-4600 Fax: (412) 431-3792 |
|
Electronic
Calibration
Scope of Accreditation
Process Instruments calibrates a wide variety of test and measurement equipment. All calibration procedures are written, and most are automated, insuring the reliability and repeatability of measurements.
Process Instruments' calibration control system complies with ANSI Z540.1, successor to MIL-45662A.
Pictured below is Process Instruments' primary DC voltage system. DC references are maintained to a half a part per million.
|
One of Process Instruments' Fluke multifunction calibration systems. Fluke's MetCal software provides automated test equipment calibration. |
Process
Instruments' electronic calibration facility certifies Multimeters, Oscilloscopes,
Counters, Potentiometers, Sensors, Amplifiers, Standards, Resistors, DC References,
Calibrators and Bridges.
Please E-mail or fax your requirements for a
quote on cost and turn-around time.
| dimensional | temperature | pressure | resistance | IR & optical pyrometers | electronics | home |
Copyright© 1997-2006 by Process Instruments Inc.. All rights reserved.
